Xplora X6Play charger and accessory mounts

Simple wall mounts for X6 Play charger and accessories.
1h 29m
1× print file
0.20 mm
0.40 mm
19.00 g
2
48
0
265
updated April 16, 2023

Description

PDF

There was no suitable horizontal surface available close enough for the kid and in range of a socket. But a cupboard would allow easy mounting on the side. The charger mount may also be useful to avoid it from sliding around or falling down.

A primary goal was to be able to easily remove the charger, e.g., for traveling. It is a simple snug fit holder into which to press the charger. The magnet in the charger is strong enough to safely hold the watch when upright.

The accessory mount stores the additional covers and strap loops when not in use.

I mounted both with power strips (double sided adhesive should work) for easy removal later, two small for the charger holder, one small for the accessory holder.

Print Instructions

This should be an easy print. I have printed in PETG because it had the color my kid liked but virtually any material should work.

PrinterMK3s+
FilamentPrusament PETG Mango Yellow
Infill15%
SupportsNone

Tags



Model origin

The author marked this model as their own original creation.

License