DnD Hit Point Tracker / General purpose counter / Clickety fidget

I needed a hit point tracker for DnD, but I was disapointed in all the ones I found. Plus they were all to small for my fingers. So, I designed this one. 

This model is big : the whole thing is 71 mm (2.8 in) x 57 mm (2.25 in), and 71 mm (2.8 in) tall.

NOTE : this tracker is blank, so you can put whatever you want on it. I did use a Sharpie to draw the numbers on mine. It can even be left blank, to use it as a fidget toy. Not in an openspace, though, as it is quite loud !

You will need :

• 1 axle
• 3 spacers
• 2 wheels
• 2 ratchets
• 1 base
• 2 indicators

Print parameters :

• .4 mm nozle
• .2 mm layers
• 15% infill
• SUNLU PLA+
• No supports needed

Assembly : 

• slide a spacer on the axle ;
• slide a ratchet ;
• fit a wheel on top of the ratchet (make sur the top side is horizontal, refit the rachet if needed) ;
• slide another spacer ;
• slide the second ratchet (make sure it's orientated the same way as the first one) ;
• fit the second wheel on the second ratchet (make sure it's orientated the same was as the other wheel) ;
• slide the third spacer ;
• put a dab of glue in the base's tabs ;
• slide the axle in the base ;
• put a dab of glue on each en of the axle ;
• fit the indicators in the base, on top of the axle. 

I will update this post when I have photos. I will print another one and put photos of the elements before assembly.