Magnetic Soap Holder Wall

A simple magnetic soap bar holder with a 22x2mm magnet that is used to hold a bar of soap.
On the bottom are two holes for screws. Alternatively you can use any adhesive strip to stick it to the wall.

The design is based on this amazon product: Link

You can use a bottle cap and press it into the soap bar as a counter part.
To further improve the design, you can drill a small hole into the cap for air to escape then you press it into the bar.

Alternatively, you can buy those caps off amazon: Link

For the magnet I've used this one here, but any round magnet with 22x2mm should wok.

Print Settings

I've used the following print settings (but other settings will work too of course):

• Material: PLA
• 0.3mm DRAFT
• Infill: 15% Grid