Asus Zephyrus G14 stand

Summary

A stand for laptop Asus Zephyrus G14 - print 2 of them.

You can improve stability by adding two pieces of 4mm diameter rod through the holes. I used unthreaded aluminum, easy to cut (about 27.8 cm long).

The large hole on top allows proper cooling (fan vents are just above this part).

Versions

• v7.1: as printed on pictures
• v7.2: not tested. Please send feedback if you are happy/unhappy with these changes:
  • width of thin bridges from 2mm to 4mm
  • height of foot part from 2mm to 3mm
  • 3 x 0.5mm high holes under the foot, that you can stick pieces of rubber to prevent slipping

Print files

• Below : v7.1 gcode for Prusa MK3S
• In the User print files page:
  • v7.1 for Prusa MK3S MMU2S single
  • v7.2 for Prusa MK3S (not tested)
  • v7.2 for Prusa MK3S MMU2S single (not tested)

Print instructions

Printed with:

• Prusa MK3S MMU2S printer (single mode)
• PLA red (Arianeplast eco)
• Print on flat surface (lateral one)
• 0.2 mm quality / Prusament PLA default parameters except:
  • 3 perimeters
  • increased Z support distance to 0.2 mm
• Supports under both bridges