Spinning pen

A fidget pen I made as I could not find any alternatives that were easy to print. Prints without supports if you print it vertically, or print it horizontally with supports for better strength ( I personally use the vertically one as it comes out cleaner)

0.08mm height (yea I know its slow but according to my testing it creates better strength for the pen)

220 nozzle temp (again higher heat = better strength)

70% fan speed

 The rest of the details (print speed, fuzzy skin, etc) are up to you and the capabilities of your printers. 

Tip: add electrical tape on your pen as a grip. It can help adjust the width according to your preference and also increase grippiness by so so much.

If you found any of my models helpful or nice, consider leaving a tip?

buymeacoffee.com/SAK1