ender 3 v2 air filter hood

Hello, a little about me. 

I have gone by Mayhem since the early 90's, so I have just stuck with that (you know old dogs and all).

PRINTER :

ENDER 3 V2 MICRO SWISS HOTEND 390 STEP DRIVE EXTRUDER 4020 HEAD COOLING DUEL 4010 PRINT COOLING

PRINTED AT 32 LAYER HEIGHT

SPEED 50MM

TEMP 215 - MINE IS HIGH DUE TO HOTEND AND EXTREME COOLING.  SET YOURS TO WHATEVER TEMP YOU NORMALY PRINT AT.

SUPPORTS EVERYWHERE TURN THE MIDDLE MODULE SIDEWAYS 

CURA 5.3

SUNLU META 1.75

I HAVE INCLUDED A CLEAN VERSION AND A TAGGED VERSION USE WHICHEVER YOUD LIKE

BUILD:

PRINT THE MAIN BASE EITHER CLEAN OR TAGGED.

PRINT THE FILTER TRAY AND THE INSERT AND THEN USE

MERV 13 GRADE SHEET Merv 13 Material for Air Filters & Purification (16 Square Feet) Stops Most Particles and Some Viruses DIY Cut to Fit Face Mask Filter Inserts and Register Vents

ACTIVED CARBON PREFILTER Amazon.com: Universal Cut to Fit Carbon Pad Pre Filter Roll for Air Purifiers Furnace Filters and Air Conditioner Filters (1) : Home & Kitchen

ANY 24V 4020 FAN SHOULD WORK 

I AM USING:

Amazon.com: WINSINN 40mm Fan 24V, 3D Printer Micro 24 Volt Fans 4020 Dual Ball Bearing, Brushless Cooling 40mmx20mm 2PIN (Pack of 2Pcs) : Electronics

I MADE THIS SO IT FITS WITHIN THE CREALITY LED LIGHT BAR UPGRADE AND I SPLICED INTO THE LED POWER WIRE FOR THE FAN.

PUT THE CARBON PRE FILTER IN FIRST THEN THE MERV FILTER IN 

THEN THE FILTER INSERT WILL FIT SNUGGLY IN PLACE TO KEEP IT ALL TOGETHER.

FILTER TRAY SIDE DOWN WHEN INSERTING INTO BASE.

I LEFT JUST ENOFF SPACE FOR EITHER A SMALL AMOUNT OF HOTGLUE OR A THIN RUBBER PAD TO BE USED INBETWEEN THE HOOD AND THE BAR.

THIS IS TO HELP KEEP SOME OF THE EXTRA VIBRATIONS FROM THE FAN OUT OF THE PRINT HEAD.

IF YOU LIKE MY DESIGN, PLEASE CONSIDER BUYING ME A COFFEE.

I'M GOING TO NEED IT WITH A NEW BABY!!!! LOL

https://www.buymeacoffee.com/mayhemv01