T300 MAGNETIC PADDLES MOD WHIT REINFORCED HINGES.

This mod consists of 2 prints one for the internal hinge that normally brakes, making the shifts even more spongy and another to attach 2 magnets to make the gear changes stiffer and quicker (maybe).

You will need the following hardware for this mod:
4 - 10mm by 3mm magnets
4 - 3mm by 8.5mm or less plastic/wood screws
1 - 1.5mm drill bit
1 - 2.5mm or a bit smaller drill bit (I used 2.3mm)

Disassemble the wheel till you get to the paddle hinges you can watch this video if you need any help.
https://www.youtube.com/watch?v=cNRYRMaG5IA&ab_channel=DimSim

After you completed this part just use the 1.5mm drill to make a small hole that extends to the other side of the plastic shell as shown in picture 1.
Once you brake to the other side of the plastic shell use the bigger 2.5mm drill to enlarge the hole as shown in picture 2.

Now reassemble the wheel and use the 4 screws to attach the mod on the back of the wheel the magnets shouldn't need any glue to stay on the brackets they should be held by friction alone, you might need to use some pressure to get them in the socket if you find that they are to lose use some super glue.

More descriptive title