Lack enclosure Rasperry Camera HQ support

I've built an enclosure with an Ikea Lack.

Recently I've baught a Raspberry Camera High Quality(the one with interchangeable lens. I created a mount, which can pivot in 2 directions.

I've printed it without support.

It requires:

1x m3 square bolt
5x m3x10 screw(with flat head) to attach the camera to the plate
1x m3x16(for the screw that is vertical)
1x m3x25(for the screw that is vertical
1x m3 hand nut

Print instructions

Only the print that is attached to the lack is a bit tricky, the rest was quite easy.

printed in 0.10mm with PETG