Hose Adapter for Ryobi to Bravo SUP Inflator

This is a part I designed for the Ryobi P747 dual inflator. It enables you to use the tube for a Bravo branded hand pump (Tends to come with a lot of inflatable kayaks and SUP boards). This is only for the low pressure/high volume side of the pump. I find this option better than permanently altering the original tube and requiring additional adapters to make it work for other inflatables. So far I found this Ryobi pump to be excellent for the price. I suspect this will work on other inflators like other Ryobi models or even the Dewalt Dual Inflator as well. I'm able to inflate my 10 PSI kayak within 5 minutes with this inflator however I can't speak for anything higher than 10 PSI since I've never tried it.

Print this in PETG or anything with higher heat tolerance.  I printed in PLA and it shrunk from leaving it in the car. 

Inflator Link: https://www.ryobitools.com/products/details/33287178780

Ryobi Port Dimensions: 24mm Diameter

Bravo Port Dimensions: 20mm Diameter

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

Yes

Resolution:

0.3

Infill: 

100%

Filament: 

Use PETG or anything that can take higher temps.  I printed in PLA and it shrunk from the heat in the car.  

Notes:

• Keep in mind the tolerances are tight so you may have to adjust the size if your printer isn't very dimensionally accurate.

The inner ledge is a 45 degree chamfer and shouldn't require supports however the locking mechanisms will definitely need supports.