Watering bottle cap

Lets air in while using, so the water comes out easily and nicely

Prints in one part and without support. Feel free to use rough settings. I made mine with a 0.6 nozzle and 0.35 layerhight and it works just fine.
 

If you dont want to print out the whole snorkel, you might just cut it in slicer and put a drinking straw with the prefered lenght in the hole. Most straws should fit


I got inspired by an allready very famous model of a watering cap for bottles but i dislike the fact that the bottle crumbles while using, because no air can get in. Otherwise its lovely though.

CHANGE LOG 04.05.2024:
Added a “lowFlow” version with smaler slits. This makes it more gentle on smal plants. I reccomend using this version in general for smal plants, since it gives only soft single drops

CHANGE LOG 01.08.2023:
Reworked the shower head for better flow characteristics and elongated the snorkel part