This is the fidget toy of 2023.
1h 14m
1× print file
0.16 mm
0.40 mm
8.00 g
Creality Ender 3 S1
6
24
0
526
updated May 25, 2024

Description

PDF

It is a good game to pass the time. There are two sides of the base where magnets belong. The one side is to attract the pointer and the other is to repel the pointer. You can do many different movements with it (e.g. set the pointer in a 90 degree position and then flick it over the non-magnetic side into the magnetic one, where the pointer should then stop.
Building instructions:
When assembling, you can put the ball bearing in the large hole in the pointer. And the magnets belong in the small hole and then be glued with some hot glue (you don't need this but if you use this you have to make sure that it is flush with the 3D model). In the two base parts there are 2 magnets in each hole. Here it is essential to pay attention to the arrangement. For example, if the ball bearing is a bit loose, you can wrap tape around it.

You need:

  • 1x pointer
  • 2x base
  • ball-bearing(6mm thickness; 6mm small hole; 19mm outside)
  •  magnets (5mm x 1mm) 

Model origin

The author marked this model as their own original creation.

License