XL printable parts

All printable parts for your Original Prusa XL. The parts are divided into folders based on subassemblies.

Print instructions

• ATTENTION: Two materials (PETG and Polycarbonate) are recommended for the printable parts. Read the following list carefully.
• Download the latest PrusaSlicer 
• For 0.6 nozzle
  • Parts from PC Blend Carbon Fiber
    • print settings**: 0.25mm QUALITY, 4 perimeters, 30% Grid infill
    • list of parts:
      • x-carriage
      • y-carriage-left-base
      • y-carriage-left-top
      • y-carriage-right-top
      • y-carriage-right-base
      • entry-fs-insert
      • fan-shroud
      • dock-cable-router-parking-plate-cap
      • dock-cable-router-parking-plate-support
  • Parts from PETG
    • print settings**: 0.25mm QUALITY, 15% Grid infill
    • list of parts:
      • all the parts except the ones mentioned above
• For 0.4 nozzle
  • Parts from PC Blend Carbon Fiber
    • print settings**: 0.20mm STRUCTURAL, 4 perimeters, 30% Grid infill
    • list of parts:
      • x-carriage
      • y-carriage-left-base
      • y-carriage-left-top
      • y-carriage-right-top
      • y-carriage-right-base
      • entry-fs-insert
      • fan-shroud
      • dock-cable-router-parking-plate-cap
      • dock-cable-router-parking-plate-support
  • Parts from PETG
    • print settings**: 0.20mm STRUCTURAL, 15% Grid infill
    • list of parts:
      • all the parts except the ones mentioned above

** Note that print settings are recommended, but you can experiment with your own.