Ikea Lack cable guide

Cable guide Ikea Lack

This cable guide is wide enough to fit the Prusa Mini+ power cable.
(plus a smaller cable if you pull that through first)

Printed in: 2.1 gram PLA, 0.2mm, infill: irrelevant

Instructions

1. Get a 16mm wood drill (5/8")
2. Drill hole in Ikea Lack table, approx. 5cm (1.95"). Be careful because the Ikea Lack material resembles cardboard more than wood :-). I had to move the drill up and down a few times to make the guide fit
3. Stick cable guide through the drilled hole. 
   Optional:
4. Click the 2nd ring on the bottom side of the guide. Glue it to make sure it doesn't come off.