Mandalori-Van Emblem

I hope all the fans of The Mandalorian will enjoy this bit of flare you can add to your vehicle. I know I do! 

You can print this with all basic settings, the only thing to be mindful of is needing to switch out the filament when the printer steps up to layer height 2.2mm. You can either add a stop to your gcode, or manually pause it like I do at around the right time. The embossed layers are 1mm thick, so as long as you make the switch before the last layer is put on the effect should work great.

I printed with 3mm thick walls, 20% cubic infill, PLA, and turned on ironing to get extra smooth on top. I also printed with a brim.

Enjoy!