Multi-Tool - This contains the G-code file only -- Remixed for true multi-colour printing

This only contains the G-Code for printing on a Prusa Mini/Mini+

Added true multi-colour to the model, so that the bottom portion with the text prints completely flat without debossed text and uses a separate colour for the text on the bottom as well as the top.

The g-code file is for a Prusa Mini/Mini+ and if you are printing with Orange and Black as my example, it will run as follows:

1.  Load Orange filament before you start printing from the g-code.
2.  About 4 minutes after starting, it will unload the Orange and prompt you to load the next filament (i.e. Black).
3. After about 1 minute of printing the Black text, it will unload the Black and prompt you to load the next filament (i.e. Orange).
4. Then after about an hour, it will unload the Orange and prompt you to load the final filament (i.e. Black).

Note:  The text on the bottom will probably print cleaner than my example; if you use a smooth steel sheet instead of the textured sheet that I used.

Only g-code for multi-colour