Bambu P1P original feet upgrade

Hello!

This is a redesign of my original more stable feets for Bambu P1P - https://www.printables.com/model/447834-bambu-p1p-feet . You need to buy the original feets for Bambu P1P from here: https://eu.store.bambulab.com/collections/accessories/products/anti-vibration-feet-for-p1p

1. Bambu P1P rubber hollow feet - made from TPU 69.
2. Base for feet - it is made from PETG but you can use PLA if you want. This is the part which made the joint between the original anti-vibration rubber Bambu part and the printer.

To assemble the parts first mount the “Base for feet” whit the larger cylinder to the hole of the Bambu anti-vibration part. I use some rubber glue between the parts. Then we slide the assembled parts into each other but before that add a little glue on the end of the last round section round wall what will be the bottom of the leg. We can apply the same glue to the entire lower part of the leg. Be careful not to put glue all over the anti-vibration part of the Bamboo and to stick it all to the hollow feet which you were print, we still want this part to move up and down and slide freely inside the opening. It's should look like the photos. 

This design made this rubber feet more stable and reduces lateral sway. 

Now I will rework all this parts and made a new build which then can be printed from TPU material and I will try to use the existing design of the Bambu anti-vibration legs but as more stable version.

If you like this hit one thumb up and comment :)