Headphone Holder for Mic Stand

The attached STL file needs to be printed twice. The two halves are then assembled directly on e.g. the mic stand.

Additional material to clamp the pieces together (suggestion):

• 2 x M3 nuts (in the pictures shown locking nuts with polyamide inserts BN 637 were used)
• 2 x M3x10mm cylindrical screws (e.g. cross-head)
• For better friction, a rubber band can be cut into pieces and glued onto the parts

The model prints fine with 0.12 mm and 0.2 mm layer height. No brim, no raft, no supports needed.

[UPDATE] 17.10.2025
Addition of two bigger designs to fit diameters d=16 mm and d=22 mm respectively. The original design is intended for diameter d=14.5 mm.