Sodacan lid cover

• This model prevents bugs from diving into your drink, as well as debris.
• This model prevents almost all water from leaking if it endures getting knocked over, however if the drink is carbonated the pressure will build up and explode if the cap is removed…
• The cap should be put on using your palm, you can either twist firmly or pull up the cap to remove it.
• If your drink or debris makes it on the cap, it should be washed with room temperature water, warm or hot water will shrink it.
• If it does not fit do not try to force it to fit (I crushed and exploded a can)
• It can hold a bit of gas, not much though the drink will still go flat after a while
• Cans with different shape like red bull or some beer cans may not fit properly 

This model prints best at 0.15mm layer height, anything lower will cause some quality issues (for me atleast)

Should take roughly an hour or two to print, this can change depending on your speed or infill amount, I use 10% lightning with 6 top and bottom layers

No supports required