Bosch Electric Drill PSR 18 LI-2 Holder for (Honeycomb Storage Wall)

Stylish holder for Bosch electric drill/screwdriver PSR 18 LI-2.

### Update 19.09.23 - Version 2

• Increased thickness for more longevity
• No more screws and nuts are required, only two empty inserts (attached to this model)
• Additional hooks in the front so the drill can't slide down. 

Printing recommendations:

• Print it laying flat (see screenshot of Slicer) for increased lateral strength
• Enable supports

----------

Version 1

What is needed?

• 1x print file
• 2x M3 Nuts
• 2x M3 screws (M3x6-M3x12)
• 2x ‘insert-with-M3’  (See original Honeycomp Storage Wall)

How to print?

• Print with the two hooks pointing up (I haven't had any problems with layer separation)
• Make it strong enough (4 Shells+)
• No brim, no supports needed.

### Update 19.09.23 - Version 2

• Increased thickness for more longevity
• No more screws and nuts are required, only two empty inserts (attached to this model)
• Additional hooks in the front so the drill can't slide down.