LED PCB Spacer for Banggood RGB LED Canton Tower kit

This is a little spacer block for evenly spacing out the 32 "rings" of LEDs in the Banggood RGB LED Canton Tower kit. (https://uk.banggood.com/custlink/3vKYokPDv)

I'm making a series of videos detailing the process of building this kit, here's the links:-

Part 1 - the intro and unboxing video - https://youtu.be/80xEHzgpSfw

Part 2 - building the main PCB - https://youtu.be/JvUHCe0f5CE

Part 3 - building the interconnect PCB - https://youtu.be/9cFhkjX0S_Y

Part 4 - Soldering up the LED PCB's :- https://youtu.be/c1Qd4M8edwE

Part 5 - Assembling the Tower of LEDs (where this spacer is used) :- https://youtu.be/iHrG6jx0ZJQ

Part 6 - Wiring the Tower & 1st test :- https://youtu.be/yYqN3D-mwAM

Part 7 - The Finale (or is it??) :- https://youtu.be/SD521vIF_G4

Part 8 - Demo of display modes :- https://youtu.be/h9ekcKVZD8k

This is designed to be symmetrical so that it doesn't matter which way it is used, and is designed with a concave base to sit over the 5mm LED, and then a 2nd spacer can be attached by it's little handle/tang into the square hole so that it is aligned to the same height (see pics for detail) Then you can solder up the joints where they are supported before soldering the rest up (there's 16 solder joints to be made on each completed LED "ring", but if you just solder up just the ones above where these support spacers are, that will hold it level, and if it's not level you can easily reflow one joint to adjust)

The spacer as designed will allow for nearly a 1 meter tall tower.

Print at least 2 of them, and if you lay it on on it's side in your slicer you won't need any supports.

Print Settings

Printer Brand:

Anet

Printer:

A8

Rafts:

No

Supports:

No

Resolution:

200

Infill:

15-20

Filament: Sunlu PETG white