I3 MEGA base plate + cable and bowden holder

Base plate - REMIX - higher version (belt holder is more to the rear side), as original (nonremixed) version kept the belt off the pulley axis - original plate here: https://www.thingiverse.com/thing:4838191

Cable and bowden holder - my own design - for those who want to have a roll of filament always on the table and not on the frame. Screw it on the right Z frame instead of original extruder. Insert cable and screw-in bowden adapter from original extruder. SUPPORTS NEEDED. (I still haven't fully finished the direct-drive conversion, so only an illustrative photo of the holder, without bowden and without extruder cable hidden in the cable sleeve)

Layer: 0.25mm

Infill: 30%