Bambu Lab X1 Rear Vent Adapter

This magnetic adapter is for the Bambu Lab X1 printer.  

The adapter allows you to attach a vent hose and pipe the fumes out of the room or the immediate area.

This adapter fits a 3" air duct hose.  This adapter also uses four (4) magnets (0.5 inch diameter, .010 thick).  The mounting holes for the magnets are oversized (0.51 diameter) for an easy fit.  Depending on you printing tolerance, you might need to super glue the magnets in place.

The magnets hold the vent adapter in place, but will slide around if moving the printer.  Once your printer is in place, the vent will stay in place.

Filament - I used PLA+ or PLA Carbon Fiber

Support - None

Brim - 5 to 8mm

Layer - 0.2mm

3mf file using Bambu Lab Studio (slicer)