Unifi Protect G3 Instant mount for P1P companion cube case

I needed a mount for my Unifi Protect G3 Instant camera. As I was just printing the companion cube case for my P1P, I used one of the top corner pieces to add a slot for the wall mount of the camera.

It slips in and hold tight with the wall mount of the camera, so you can easily adjust the angle of the camera.

Night vision works nicely so you can watch your prints without any light source.

(Do this on your own risk!) Please note that you have to open your camera to adjust the focus of the lense. For this, peel of the rubber on the bottom, remove the three screws and then search for the clips around the border so remove the back shell (disconnect the microphone to remove it completely). Then agian remove two screws to remove the board from the front shell. Now you have access to the lense. Take a pliers and gently (!) rotate the lense. It is glued in to keep its manufacturers focus, so you have to use a little bit force until the glue gives up. But be extremely careful to not damage the lense. Plug the camera in and look if the focus is at around 19cm. After that you can put the camera back together again.