UNO Card Box Multicolour

This is a card box for UNO with 3D UNO letters based on the UNO Card Box by @Markus_p.

You can slice it to have the lid, the base of the logo and the logo in different colours (In this case lid - prusament galaxy black, logo base - clear red, letters - glitter red).

You will need 6 M3x30mm screws and glue. 

In this case I used M3x40mm screws and sanded them down to about 33mm and added an M3 nut on each screw. I also used epoxy adhesive for the inner box but superglue will work just fine. Printed on a prusa mini.

Instructions:

Glue the inner box to the bottom with the small dot facing forwards. Assemble the pieces like in the picture and put the screws where necessary. Be careful not to tighten the screws too tight.

Please note this is an unnecessary complication of the original model it's based on.