Netherlands/Nederland [ACTION] Re-load desktop fast charger mount

Wall mount for the Action Reload desktop fast charger:

https://www.action.com/nl-nl/p/re-load-desktop-fast-charger/

Currently around 12 euros.

Doesn't get hot so vents weren't needed. Mount is robust ( might even say too ). Wall thickness is thick because i like my mounts sturdy. Printed mine in ABS, but should work for most materials.

5mm holes so if your screwhead is larger then 5 mm and the shank is 5 mm or under they will fit.

3mm thick walls.

5mm thick wall mount sides.

Has a latch to secure it from comming out. However as is the print is a SUPER tight fit. And wouldnt need the latch. it was made to exactly fit. However if your printer isnt 120% calibrated, enlarge the entire model by 1-2% and maybe even more.

Insert Charger before wall mounting as the screws also secure the clip from getting undone. I did this so that the visuals look uniform when mounted. If theres a desire for a removable one so that the mount stays but you can move the charger around, hit me up ill modify it.

Should be printed in the orientation that it loads in.

Supports : YES

Material : ANY non flex

Infill : >10% reccomended, i use 20% but you could of course go to 100%

Adhesion assist: Brim (reccomended, taller print, low surface area so no brim Could be detached ).

Print size: 100% (super tight fit ) 102% ( safety margin )