My sundial bracelet

Print bracelet parts in the right length and clip them together. Use the clasp to attach the bracelet to your arm. It is best to get help with this. Otherwise there is the danger of getting stuck.

Flip up the pointer and keep the watch facing south so that the hand casts a shadow on the dial.

Print instructions

All parts can be printed without support.
Material should be PETG.
Layer height: 0.2 mm
Infill: 20 %
Temperature was
235 °C for first layer, 230 °C for other layers
Bed had 80 °C

After printing turn the watch and free the pointer by a sharp knife. Only the first layer needs a cut.