Masters Coaster

I printed this with the MMU, but it should be able to be assembled in separate pieces.  It would be a tight fight because there aren't any tolerances built in.  A bit of persuasion would get it to fit together.   The flag would need to be glued to the flagstick, unless you print it as one piece and paint the flag. 

One thing to note.  The photo shows the yellow/green portions as flush.  This wasn't by design.  In the model the green sticks up a little bit to make it more “coaster-ish”.  But when I went to print it, I was really low on yellow filament and it looked like I wasn't going to have enough to finish the last layer of yellow successfully.  I stopped the print before it could run out of filament mid-layer. 

The hole for the flagstick is also tight.  I used cutters to cut the end to a point to make it easier to get in.  You can adjust the flag height to whatever you need and cut off the excess. 

Happy Masters Week!