Sovol SV05 Chain

This is a cable chain holders for the Sovol SV05.  Going across for the Extruder Carriage to help keep it out of the way and from getting caught on the Y Axis when moving out.  The filament guide can help to keep it out of the way also.  

As such, you will need:

• M3x12 Screws x3
• M3 T-Slot Nuts x3
• Small Zip ties

Printing Requirements: 

• One Carriage Rider (Supports Needed)
• One of the Cable Guide
• 30 of the Cable Chains 

To install in the back you do not need to take the back bar off, this can be done more with the placing the t-slot nuts in the groove of the back 2020 bar, and turning them in place. It can be a little bit touchy but easiest to do.  Also you will have to take the cord that leads up out of the cable cover on the SV05 to make this work.  It isn't long enouhg otherwise to get to the farthest corner.

To attach to the carriage, it should be able to just settle and be snug as it fits on the actual metal. You will have to remove the zip tie that is holding the cable to move it.