Atomrc Swordfish VTX Tray for Walksnail V1

This is a tray intended to make for a cleaner mount of the Walksnail VTX onto the Atomrc Swordfish. It fits into the fuselage using the stock nylon screw, and holds the transmitter, as well as the antennas. The transmitter is placed high up and exposed to plenty of airflow to keep it cool. You can quickly remove the tray/vtx/antenna assembly to access the space below if needed. There's two files included, one for use with the stock V1 antennas (or any with a 3mm post/stem), and one for use with 4mm antennas, like the RushFPV Cherries or HGLRS Hammers. Probably best printed in PETG or other higher temp filament to handle the heat of the VTX when sitting idle on the ground. Needs support under the tabs. Uses M2x12mm screws to mount the VTX, they thread right into the plastic.

4/5/23 Updated to "RevB", added cutouts to allow more room for the serial and USB wires, and taller posts under the VTX. Also added a bit of material to better fit a USB-C port, glued to the bottom of the tray. This is the port I used - https://amzn.to/3MlA4O9