Stand for Ipad (2019)

Hook on stand for iPad 2019. It is designed to lock at three positions with a spring mechanism. Spring dimension is given in pictures.

Print instruction:
No supports needed for all parts.
Parts with threads should have 0.15 layer height.
Rest of the parts can be printed at 0.20

Infill: The M8 bolt should have at least 50% infill, 20% is ok for rest of the parts.

Look at picture for print orientation.

Print instructions

No supports needed for all parts if you orient them as intended by design, see picture. Parts with threads should have 0.15 layer height. Rest of the parts can be printed at 0.20 - Infill: The M8 bolt should have at least 50% infill, 20% is ok for rest of the parts. - Look at slicer picture for print orientation.