CP-140 Aurora / P-3 Orion Plane Geometric Art

This model only uses 8g of filament and takes about 2.2 hours to print. 

This model can be difficult to get a good first layer due to the thin structures. I have found that turning off the Optimize Wall Printing Order setting in Cura would make the thin wall structure print in a better order for good first layer adhesion. I also used a 0.12mm layer height and slow print speed which helped with the first layer as well.

Settings:

Layer Height: 0.12mm
Extrusion Width: 0.4mm
Shells: 3
Infill: 20%
Top/Bottom Layers: 4