Angry Eggs - Red and Green

I was inspired by #hairy3degg from Mat3d_Prints, 

who has used uses "Fuzzy Skin" on a simple egg with great result.

Then i just created one Red and one Green egg, with use of Fuzzy Skin only in certain areas of the egg. 
The result is a very nice looking {but little Angry} eggs :-) 

For the printing in PrusaSlicer just load the “main” egg model (Angry_Egg_Red.stl, Angry_Egg_Green.stl), then give on this egg “Add Modifier” with the "Load" option and add the coresponding ***_Fuzzy.stl. The next step is to add “Fuzzy Skin”(FS) function to this object, turn it ON with the “outside walls” option and Slice it. Thats all.
I used 1.0mm for the FS point distance and 3.0mm for the FS thickness. (feel free to experiment with those values).
Used 0.4mm nozle and 0.2mm layer height without any support.

A quick guide for PrusaSlicer here: