Herb Grinder
The Herb Grinder with the joint.
470
5071
37
22 k
updated March 6, 2024
Makes
Comments
Wanted to make an "Oreo" styled Grinder.
Thanks for the files, worked great!
0,1mm layer
100% infill line
Top & bottom: Bambu X1CC
Middle: Bambu A1 Mini
printed with eleego transparent pla, without calibration, printed really good, nice modell, thanks for sharing.
Does it scale? We'll find out in the morning.
Really nice Grinder. I change it so I could use magnets instead of the ball joint.
Material: Flashforge Burnt Titanium PLA
@Bloodwyn_1033015 I'd love to do the same modification. Could you share your file please?
I needed something to grind down some catnip that was a little too prickly for the kitties and this works great!
So I printed it for grinding decorative moss / herbs (not plastic), but it didn't really work - the herbs are simply too big to be grinded with such a small tool.
Also the holes are too small for the moss to pass.
The grinding teeth are too close together (makes sense), but it's hard to pick out the herbs and re-use them.
But otherwise, it works.
Because there were a few problems during the printing, the little columns were much less stable and broke off. Still a great grinder!
