Flight Scope Mevo+ Stand v2 (Heat-Set Inserts)

Design highlights

• Uses minimal filament to print
• Prints fast (about 2 hours)
• Defaults to the optimal 12°
• Angle is fully adjustable with the feet
• Attached to the stand using the front tripod mount
• Separate floor alignment guide 

Version 2 changes

• Heat-Set Inserts no printing threads
• Remove the bubble level
• Use a different bolt knob
• Floor alignment guide
• Uses M5 Heat-Set Inserts

Non-printed parts

• M5 Heat-Set Inserts x 3 (Lenght 5mm - Outer diameter 7mm) (https://www.aliexpress.com/item/1005004535859664.html)
• M5 bolts x 3 (35mm approximately)
• 1/4"-20 Male Threaded Tripod bolt

Print Guidelines

• Printed in PLA+
• Print with at 3 walls/perimeters
• Infill 15%
• No Supports required