Pan flute

Printable pan flute. It sounds ok but I’m not en expert ;)

Printed with PLA, layer height 0,2 or less(Upside down on the build plate. 2 perimeters, infill 15%, use support only for the mouthpieces and bridging for the end of the pipes). 

The quality of sound depends mostly on the accuracy of your printer. For the fine tuning you can use soft candle wax and for example pencil to push the wax in the tube to change its depth. You can also print a cilinder with little smaller diameter than inner side of the pipes (works better than pencil).  Look on YouTube how to tune pan flute. 

The optional flute band is a little bit loose. I had to use a glue to fix it in place. But this again depends mostly on accuracy of your printer.