Steam Deck Clip On Stand Slim (Fit in Carry Case without remove)

I really like the original design, but I have to remove it before put my deck into the carry case which is a bit annoyed.

So I refer to the original design and redesigned a carry case compatible version.

You would need super glue instead of M3 thread in this design.

2023/5/7 update:

After use it for a while, I found out it is too fragile.

So I upload a stronger V2 version. I suggest you to print that version instead.

Print settings

You should print without support, your printer would bridge the gap.

Suggest layer height: 0.2 mm