NEW Model Now Available - Ender 3 S1 Pro Filament Runout PTFE attachment - Remix
I remixed Valeriy Proklov's model by adding clips so it stays on - no hardware needed.
20
120
3
1024
updated November 4, 2023
Description
PDFNEW Improved Model Now Available click this link!
11-3-2023 - Fixed PTFE hole. Version 6.1 has the taper taken out and the hole is sized for a better fit and a tubing stop was added.
I remixed Valeriy Proklov's model by adding clips so it stays on - no hardware needed. The top hole for the PTFE tubing is a bit tight and might need clearing with a 4mm drill bit.
Printed with Atomic PLA with supports. 0.4mm nozzle/0.45mm line width, 0.2mm layer height, 2 walls, 1.2mm top/bottom, 20% cubic infill.
Tags
Model origin
The author remixed this model.
Ender 3 S1 Filament Runout PTFE attachment
Original model was switched to draft or deleted
Differences of the remix compared to the original
Clips added to hold the guide to the filament run-out sensor.
