Canned Pet Food Lid

I needed a lid that could go onto the open cans of cat food the keep them out and and the food in.

The brim of the cans I have is 76,6mm wide, if you have larger or smaller cans you might be able to resize the lid to make it fit for your cans.

Don't have a printer yourself? Contact me on my Etsy store and I'll be happy to print it for you: https://www.etsy.com/shop/XDr4g0nX3DPrinting

Print Settings

Printer:

Gemstock - Azurite

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

0.15mm layer height

Infill:

100%

Notes:

I printed this in PLA to have a good snap when putting the lid on, I also printed it with 100% infill to make it airtight.

I have also tried flexible filaments but they didn't give a good enough seal around the cap with my settings.

Category: Pets