I saw the other comment about different length screwdrivers. I measured mine and scaled up the height on my print. The drivers fit very well.
I looked at the option of shortening the shafts, but mine had a flat spot ground to accept the 2mm set screw. I did not want to grind another flat, so I left them at the stock height. Thankfully, this design was flexible enough to accept re-scaling well.
Works great. Will have to remix for use with MIP hex drivers I have, as they have a larger barrel. But they fit the basic set of hex drivers well.
Great design, but after printing noticed my drivers were longer than the design. Will have to work on a remake in the near future. But for now will work.
@Kenndowl_753588 Good point. I shortened mine by loosening the 2mm Allen key on the handle, so they are shorter.
@DanZ_476227 Thanks for the tip.
