Water or Wine bottle storage rack

Horizontal drink bottle storage rack designed to fit on shelf 260mm wide x 260mm high.

UPDATE: photos are of my prototypes that I continue to use. I updated the design after the photos were taken to:

• Correct some errors,  
• Prevent overhang fails (so it can now be printed without supports) 
• Increase surface area for gluing the LHS and RHS sections together

Made in 2 parts (LHS & RHS) to fit on build plate of 220x220mm. You will need to glue the two parts together.

Bottle rack is narrower than full shelf width so there is clearance to slide it in or out past the door.

bottom 2 levels fit bottle diameter (79mm)

top  level can fit a Nalgene bottle (92mm)

printed with PLA, 0.3 layer. no supports needed if printed face down