Pigs Fly

Little winged pig I made to fly. It doesn't require supports on the overhangs but I painted some on the face (and wing base just to be sure) because the snout was too little surface area for good bed adhesion, even with a big brim. 

The tail is just a free standing spiral that protrudes from the fuselage. I slowed that layer way down because the printer likes to pull away too fast when starting it, so this strengthened the connection. 

It printed just fine at 0.2 mm layers with a 0.6 mm nozzle. The overhangs are not very drastic so it should be able to handle bigger layers too. I also printed it hollow so that works out too.

There are intrusions and protrusions in the face for its mouth like a shark plane and its eyes wearing aviator goggles. I meant to paint them but couldn't get my supplies in time