Voron 0 led clippable mount

I scaled the original design in half on the Z axis to fit it in the Voron0. You'll need 2 per strip for adequate lighting, I also suggest you print 2 more to have a strip on both sides. They clip onto the extrusions and you can place them wherever you like, like on the underside of the Y extrusions or on the vertical extrusions of the frame. I'll upload photos when I finish my installation but you can find one in the page of the original design. 

PETG or any material with higher thermal resistance should be used. I suggest 0.2mm with a large brim as the base surface is very limited. Keep the original orientation otherwise the clips will be too brittle or even unprintable. 

For more information and instructions please visit the original page bellow.

All credits go to https://github.com/julidau All I did was to remodel it to fit the V0.