Made this since there are too few in the box from store and not avaliable seperatly.
Pressfit contact and exact dimension as original, may need some fine filing since no box/printer is exact with 0.01mm messurements. May need to hammer down with rubber mallet, but they are sturdy and can be lifted again with a small crowbar if missplaced.
Good to know:
Non-branded PLA ( should work with any filament)
0.2 thickness
2 walls (with outer wall drawn first)
Infill: 5%
No supports
Reach out if you have any questions or need other designs.
Thanks!
The author marked this model as their own original creation.