HX711 enclosure

I'll need a touch protection for the electronic component nearby a load cell. On picture 2 you can see this was made for the pcb with the red frame. But this pcb didn't work for my project. So I used the other one. If you have the same problem you must cut one of the upper parts of the pcb holder, then it will fit too. In the last picture you can see it closed.
In the x.3mf file you find a block to rise the load cell from the frame. This riser (or similar) is necessary for usage of the enclosure.

This enclosure has a cable break out window, the wall is 0,2mm thick. This is made for print support only. Not intended to used closed by me.