Check out Prusa's Black Friday Deals. Only valid until December 3rd!

Eurorack Faceplate for Akso Synth Board

Designed to be as slim as possible at 2HP wide.
2
30
1
394
updated October 18, 2020

Description

PDF

UPDATED 29/04/2021: With Corrected hole spacing and a variant with an extra jack for people DIYing stuff

Designed to be as slim as possible at 2HP wide. The rear of the panel has a number of ribs to provide additional rigidity to the panel and on the edges standoffs to screw the Akso to the panel to better support the USB C connectors.

More info about the supported board can be found here https://zrna.org/akso

Print instructions

Single Part Print at 0.2mm in default orientation no supports required. Akso Screws in with 2 M2 bolts and nuts once again try to get a low profile head or it might protrude too much.

Tags



Model origin

The author hasn't provided the model origin yet.

License


Highlighted models from creator

View more