Bear Extruder X Carriage for Anet A8, AM8 46.4mm rods

NOTE: While this model works great, I recommend using my A8 Bear X Ends instead (https://www.thingiverse.com/thing:3813648). They allow for the use of all the unmodified Bear Extruder parts.

Bear Extruder X Carriage for Anet A8 or AM8 with 46.4mm rod spacing. This is a remix of the 0.6.0-alpha version of the Bear Extruder.

If you are using igus bearing on your current carriage, you will probably need to switch back to standard lm8uu bearings as the clamps deform the igus bearings causing them to bind.

9/26/19 Added the fixed Bear 0.7.0 mk3 X carriage.
9/8/19 found major issue with 0.7.0 mk3 carriage. It has been removed and will be replaced soon. (FIXED)
8/29/19 added 0.6.0 mk3 and 0.7.0 mk3 carriages.

Print instructions

Category: 3D Printer Parts Summary

NOTE: While this model works great, I recommend using my A8 Bear X Ends instead (https://www.thingiverse.com/thing:3813648). They allow for the use of all the unmodified Bear Extruder parts.

Bear Extruder X Carriage for Anet A8 or AM8 with 46.4mm rod spacing. This is a remix of the 0.6.0-alpha version of the Bear Extruder.

If you are using igus bearing on your current carriage, you will probably need to switch back to standard lm8uu bearings as the clamps deform the igus bearings causing them to bind.

9/26/19 Added the fixed Bear 0.7.0 mk3 X carriage.
9/8/19 found major issue with 0.7.0 mk3 carriage. It has been removed and will be replaced soon. (FIXED)
8/29/19 added 0.6.0 mk3 and 0.7.0 mk3 carriages.

Print Settings

Printer: Anet A8

Rafts: No

Supports: Yes

Resolution: 0.16mm

Infill: 25%

Filament: Any ABS/PETG