Wall-Mounted Power Strip Holder

I have several power strips in my house that tend to fall over or move around when a cord is moved.  These brackets are designed to go around the power strip and then screw into a wall, baseboard, desk, or wherever to keep them in place. Works fine with one if the power strip is on the ground, but works better with 2 printed and attached at either end. Definitely use 2 if wall-mounting.

I made a few for the size of power strips that I had. I'm sure they can be resized slightly and still work well. Measurements listed are internal (the size of the opening) and the mount is 3mm in thickness.

Pay attention to orientation of the screw mount as well.  There is a version with holes (for less material use, lighter weight) and a version without holes for each size.  Picture shows what each looks like.

Printed on its side with no supports at .2mm PETG or PLA (PETG preferred if weight-bearing) on a Prusa Mini+.