J1772 EV Charger Holder - Remix

Similar to my other model, but the charger is inserted perpendicular to the wall.  This provides easier access, but does make the charger stick out further from the wall.  The whole reason I made the first one was to get something flat up against the wall to save space.  Then I changed where I parked/charge my car, and found that the ‘flatness’ of the first model was no longer needed.  Life's funny like that.

Same distance between the two mounting holes.  So if you printed the first one and want to try out this model, you can use the same mount points.  

If you print with the “wall” side of the model facing down, then you don't need supports (no angle greater than 45 degrees).  I recommend PETG.

If you download the model, please do me a favor and hit the “LIKE” button too. Thanks!

Changed the handle orientation