Toy truck trailer support

My son's cheap toy truck trailer broke a bit so I designed this replacement part for it.

This has one more screw hole than the original part for a better connection. Original part has a tiny plastic pin instead of the third screw which wouldn't have worked as a printed piece (would have snapped off too easily).

This part probably works ok by using only the 2 original screws and leaving the third screw hole open, but work a bit better if you find an extra screw similar in size to the originals and use that for the third hole.

Print instructions

• Supports: No
• Layer height: 0.2 mm
• Infill: 25%
• Perimeters: 4
• Top solid layers: 6
• Bottom solid layers: 3
• Detect thin walls: on