Star Layered Texture Vase Mode Trophy With Stand

A 2 part make with a vase mode trophy cup. Printed in Oh My Gold PLA on a Prusa Mini with 0.4mm nozzle, but larger nozzles would be better. Each layer is 2mm thick, which you can reference if you wish to scale it. 

Be warned that the largest gap for bridiging is 5 cm, so if your printer can't handle printing strands at this level, I recommend scaling the trophy down or tweaking your print settings. NGL this was challenging for me to print compared to my previous vase modes. I'm not sure if its a filament issue or design issue, since the filament was also causing problems for my other prints. Either way, you may want to cut the model near the bottom to test the base where there are the most issues. Also be careful when removing the trophy from the print bed.

There are 2 cup designs, one with a hole in the top and one with a covered plate on the top. The thickiness of the plate is 2mm(1 layer), and you should be able to add text there. Just ensure that its is a deboss and not emboss.

I also advise checking out the different bottom layer fill pattern as that will impact how the top of the trophy will look like. I recommend concentric now, but things may change when text is inolved. 

Two stands avaliable, the one in photos is the smaller version. 

If you are intersted in this type of vase mode style of trophy, or looking for a simpler trophy design, check out my other works.